Hager - Center Hung - 780-300 Series
Hager roton continuous gearedhinges are designed to provide superior performance you can rely on inhigh-traffic areas because they use a unique rotating joint, not a pin.This minimizes lateral wear on the hinge while evenly distributing doorweight along the full length of the frame. Roton continuous gearedhinges are an ideal choice for new construction or retrofitapplications.
Door And Frame Preparation
All Roton Continuous Geared Hinges are surface-applied. Cutout design and spacing coordination is thereby eliminated in both new construction and restoration work. Reinforcement plates are not required in doors or frames except where the gauge is too thin for the fasteners in relation to the door weight or where abusive operation is anticipated.
Door Closers
Conventional surface or concealed sliding closers may be used with Roton. (Note: Pivot type floor closers with a fixed, conflicting pivot point may not be used). Closers will last considerably longer, adjust to operating requirements more readily and show consistent settings due to the reduced operating forces of Roton hinging.
Hager - 780-300 Specifications:
Clearance: 1/32" (1 mm) minimum recommended between door and frame
Fasteners: Dril-Kwik® screws
Length Options: Standard and Custom
Door Reinforcement: None required to 200 lbs. Heavier weight use 16 gauge channel
Frame Reinforcement: None required to 200 lbs. Heavier weight use 16 gauge channel
Special Features: • For center hung door application
• 3/4" (19 mm) minimum inset